Quadro 6 port FXO: The Gateway to PSTN, FXO Extension and/or Mini POP

The Quadro FXO is a modular approach to adding additional outside PSTN lines (POTS) to a corporate phone network that utilizes an Epygi Quadro IP PBX. Each QuadroFXO is a stand-alone SIP gateway device with 6 outside POTS lines. Multiple QuadroFXO gateways can be added to a Quadro IP PBX depending on how many additional lines are required. Uses include the addition of inbound lines, the balancing of outbound call volumes from a combination of analog and IP phones, fax lines, E911 emergency lines and individual direct dial numbers for each salesperson.

Connected via Ethernet to the LAN interface of a Quadro IP PBX, QuadroFXO delivers six addional POTS lines for PSTN calls. Minimal configuration is needed, the Quadro IP PBX will automatically use the new POTS ports and present them within its management system as additional FXO lines. These lines may be co-located with the IP PBX or located remotely as an “extension cord” to another office in another city or even another country.

The QuadroFXO can be used as a low cost, mini Point of Presence (POP). In this configuration you remove the IP PBX altogether by assigning VoIP network DID numbers from an ITSP directly to the QuadroFXO lines. Think of it as a smaller scale alternative to the QuadroE1/T1 gateway. It truly is the lowest cost for creating a local presence anywhere on the globe.

PBX Features

• Call block, unconditional forwarding
• Call statistics
• Call routing
• Auto Attendant
• T.38 fax, fax relay and clear channel fax

Internet

• NAT address translation
• STUN/NAT traversal (RFC 3489)
• Firewall security via:
• NAT (Network Address Translation)
• Policy and service-based filtering
• DHCP server on the LAN side
• DHCP client on the WAN side
• DNS server with forwarding functionality
• SNTP (Simple Network Time Protocol) server/client for computer clock synchronization
• PPPoE connection to the ISP with PAP/(MS)CHAP authentication
• IP DIFFSERV for QoS
• DNS support with third party
• Port forwarding
• Port translation

Management

• WEB interface accessible from LAN and WAN (HTTP/HTTPS), the WAN management access can be switched off
• Password control
• Remote diagnostics and software upgrade
• Downoad/restore configuration
• Reset button with factory reset option

Connectivity

Extensions

• Up to 70 virtual extensions
• System Capacity
• 6 simultaneous IP-PSTN calls

Premise Connections

• 1 Ethernet 10/100BASE T port (RJ45)

Uplink Connection

• 6 FXO ports to the Central Office (RJ11)
• 1 Ethernet 10BASE T (RJ45)

Power Supply

• Input 100 - 240 VAC; 50/60 Hz; 0.5 A
• Output 12.0 VDC; 1.5 A

Regulatory Compliance

• EMC: FCC Part 15 Class B; EN55022 Class B, EN55024;
• Telecom: CTR21/TBR21